 |
|
|
We are the leaders in high performance protective coatings in India for over 45 years caters to the different environmental and industrial corrosion protective requirements be it concrete or steel substrates with products that have attained instant recognition, worldwide, and continues to meet quality requirements that are demanded today even in the domestic high performance coatings market. All their clients recognize Berger as a quality vendor and we have in place ISO 9001 systems of quality governance.
Our Range :
|
| | Linosol High Build MIO CoatingRecommended for long term protection of steel structures in coastal or moist, polluted industrial environments. Petrochemical complexes, refineries, tank farms, bridge work, fertilizer plants, sewage plants, docks and harbour installations are some examples where the products can be used. Specifications: - Type : Single Pack
- Composition : Plasticised chlororubber medium/Micaceous Iron Oxide
- Application : Brush or Airless Spray
- Recommended DFT : 50-75 microns per coat
- Corresponding WFT : 100-150 microns per coat
- Theoretical Spreading Rate : 6.7-10.0 Sq. Mtr./Ltr.
Refer pdf for more information.
|
Super High Build Coating Uses : An ideal chemical resistant epoxy coating recommended for application on ms and concrete structurals, pipelines, tankage exteriors and offshore installations. The coating is suitable for refinery and petrochemical units. Chemical and other highly corrosive industries in both new construction and maintenance situations.
Scope: A super high build epoxy coating capable of asset protection in single coat. It protects both ins and concrete from chemicals, solvents, and aggressive exposure conditions. Specifications: - Type : Two Pack, cured with Aliphatic Amine
- Composition : Catalysed Epoxy resin, suitably pigmented
- Mixing Ratio : Base : Catalyst- 4 : 1 by volume
- Application : Brush for small areas. Conventional pressure pot or Airless Spray.
- Pot Life : 60-75 minutes at ambient conditions
- Recommended DFT : 125-300 microns per coat
- Theoretical Spreading Rate : 4.25 Sq. Mtr./Ltr. at average 200 mic DFT
Refer pdf for more information.
| |
| | Bison High Build MIO CoatingRemove grease, Oil and other contaminants preferably by using bison degreasing solvent blast clean to a minimum of sa 2 swedish standard 515 05 5900 with a surface profile not exceeding 35-40 microns. If blasting is not practical, make full use of mechanical tools along with manual chipping and wire brushing to remove loose rust and scale to st. 2 swedish standard sis 055900. Excessive burnishing of steel is to be avoided. Thoroughly dust down all surfaces. The surface should be clean and dry before application of a suitable primer.
|
|
|
© Parag Sales Corporation. All Rights Reserved (Terms of Use)